Bildegalleri
Megasquirt 2 datasprut
Til salgs
4 500 kr
Beskrivelse av varen
Selger her Megasquirt 2, følger også med chip`n for MS1. (noen biler som må bruke den versjonen).
Følger også med simulator (slik at du kan simulere alt på pc'en FØR du kobler den opp i bilen din.
Megasquirt kan brukes på alle bilmerker 4, 6, 8 +++ sylinder...
Alt er helt nytt!! Selges kun fordi prosjektet har blitt lagt på is:(
Litt info på engelsk:
MegaSquirt II includes all of the features and benefits of the original...
Onboard MAP sensor for NA or boosted engines up to 21psi!
Speed density or Alpha-N.
Use any injector - High or Low impedance.
Compatible with output from narrowband and wideband O2 sensors.
Log data on your laptop for later analysis.
Tuning software is free for download and regularly updated with new features.
Open Source design - all code and hardware information is available online.
Includes proper female DB37 connector and shell for building your wiring harness.
Additional Features new to the MegaSquirt-II
24 MHz HCS12 processor,
Fuel control to 1 µsec (100 times more resolution than MegaSquirt-I),
Ignition control (full spark timing advance control, dwell control, etc) for one coil/distributor (7 pin HEI for example) and Ford's EDIS systems,
On-board stepper motor driver for IAC stepper control (this requires a few jumpers to be added on the MegaSquirt PCB to connect the socket jumpers to the DB37 connector),
Ford PWM idle valve support,
Built-in rev limiter, either 'fuel cut' or 'spark retard',
All tables are now 12×12 in size,
WBO2 AFR target table (in AFR units),
Independent dual-tables for VE and AFR target,
EGO feedback in wide-band mode is proportional to the difference between the measured AFR and the target AFR, the bigger the difference, the bigger the feedback step,
Spark advance table can have different rpm and kpa bins than VE and AFR tables,
115,200 baud serial interface with MegaTune2.25+,
CANbus networking
Barometric correction amount and direction configurable in software, and provisions for:
barometric correction based on initial MAP reading,
independent 2nd barometric MAP sensor for continuous real-time baro correction, or
no baro correction.
TPS values for open loop and flood clear mode are user configurable,
MAP based open loop can be set as well as TPS,
Both TPS and MAP based accel enrichment is built into the code, you can configure the ratio of each,
Blended Alpha-N and speed density is an option,
2 spare I/O lines for custom controls. (This is in addition to 4 lines for Idle stepper control if you don't need this, or the Fast idle solenoid then becomes a spare if you do use a stepper motor.)
Brukerprofil
Du må være logget inn for å se brukerprofiler og sende meldinger.
Logg innAnnonsens metadata
Sist endret: 4.10.2006 kl. 09:45 ・ FINN-kode: 8324568