Bildegalleri
(1/1)
BigTreeTech Octopus v1.1
Til salgs
Fiks ferdig
700 kr
Frakt fra 19 kr + Trygg betaling 62 kr. Frakten er på tilbud – ordinær pris er 39 kr.
Trygg handel med Fiks ferdig
Varen sendes til deg, og du har 24 timer til å inspisere den før pengene overføres til selgeren.
Beskrivelse av varen
Type: Printere og tilbehør
Helt nytt Octopus v1.1 selges, uten drivere. Anbefaler TMC2209 eller TMC2226
https://polyalkemi.no/produkt/btt-tmc2209-stepperdriver-stepstick/
[Main Control Chip]Uses a 32-bit ARM Cortex-M4 series STM32F446ZET6 main control chip with a core frequency of 180MHz.
[Strong DIY Support]This motherboard supports up to 8 stepper drivers with 9 stepper driver outputs in total; And up to 6 PWM fans and 2 always-on fans with the ability to individually select the voltage rail that will drive each fan. Select from Vin, 12V or 5V.
[Motherboard Expansion Function]Support BLTouch, locked-rotor detection, shut down after printing, resume printing after power failure, CAN bus, U disk function, IIC expansion; at the same time reserved WIFI interface, PT100 thermistor interface (optional), dual Z-axis printer.
[TMC2209 Driver Features]The TMC2209 stepper driver is not easy to lose steps and is in an ultra-quiet mode; the module has a large area of heat dissipation pad, which can reduce the temperature of the driver when it is working; the module supports three modes: STEP / DIR and UART.
[TMC2209 Driver Mode]TMC Motor drivers can be used in SPI or UART mode by simply adjusting the onboard jumpers beneath each motor driver. Additionally, you can connect or disconnect the TMC DIAG pin using an onboard jumper allowing you to use hard end-stops or sensorless homing without the need to cut any pins.
NB: Knappen for å vise hele beskrivelsen har kun en visuell effekt.
Brukerprofil
Du må være logget inn for å se brukerprofiler og sende meldinger.
Logg innAnnonsens metadata
Sist endret: 30.9.2025 kl. 00:16 ・ FINN-kode: 285745737
